A brighter, lighter and healthier world
Home » Publications » Design and fabrication of embedded micro-mirror inserts for out-of-plane coupling in PCB-level optical interconnections

Design and fabrication of embedded micro-mirror inserts for out-of-plane coupling in PCB-level optical interconnections

Publication date 2010
B-Phot Authors Jurgen Van Erps, Hugo Thienpont
DOI 10.1117/12.853648
Citation
J. Van Erps, N. Hendrickx, E. Bosman, P. Van Daele, C. Debaes, and H. Thienpont, “Design and fabrication of embedded micro-mirror inserts for out-of-plane coupling in PCB-level optical interconnections,” in Proc. SPIE, Micro-Optics, VCSELs, and  Photonic Interconnects III, 2010, vol. 7716, p. 77161Q.
Abstract Optical interconnections have gained interest over the last years, and several approaches have been presented for the integration of optics to the printed circuit board (PCB)-level. The use of a polymer optical waveguide layer appears to be the prevailing solution to route optical signals on the PCB. The most difficult issue is the efficient out-of-plane coupling of light between surface-normal optoelectronic devices (lasers and photodetectors) and PCB-integrated waveguides. The most common approach consists of using 45 degrees reflecting micro-mirrors. The micro-mirror performance significantly affects the total insertion loss of the optical interconnect system, and hence has a crucial role on the system's bit error rate (BER) characteristics. Several technologies have been proposed for the fabrication of 45 degrees reflector micro-mirrors directly into waveguides. Alternatively, it is possible to make use of discrete coupling components which have to be inserted into cavities formed in the PCB-integrated waveguides. In this paper, we present a hybrid approach where we try to combine the advantages of integrated and discrete coupling mirrors, i.e. low coupling loss and maintenance of the planararity of the top surface of the optical layer, allowing the lamination of additional layers or the mounting of optoelectronic devices. The micro-mirror inserts are designed through non-sequential ray tracing simulations, including a tolerance analysis, and subsequently prototyped with Deep Proton Writing (DPW). The DPW prototypes are compatible with mass fabrication at low cost in a wide variety of high-tech plastics. The DPW micro-mirror insert is metallized and inserted in a laser ablated cavity in the optical layer and in a next step covered with cladding material. Surface roughness measurements confirm the excellent quality of the mirror facet. An average mirror loss of 0.35-dB was measured in a receiver scheme, which is the most stringent configuration. Finally, the configuration is robust, since the mirror is embedded and thus protected from environmental contamination, like dust or moisture adsorption, which makes them interesting candidates for out-of-plane coupling in high-end boards.
B-PHOT cooperates with EYESTvzw for STEM-projects in Photonics
STEM

Click here for more information...

Contact

Hugo Thienpont
Prof. Dr. Ir.
Hugo Thienpont
Managing Director
Nadia Cornand

Nadia Cornand
Secretary
ncornand@b-phot.org
+32 2 791 68 52

How to reach B-Phot?

VUB - Campus Etterbeek
Pleinlaan 2
1050 Elsene
Building F - 9th floor

More info